Page 1 of 2
Gilera sp01 mod
Posted: Tue Oct 18, 2005 5:19 pm
by Rubberduck
so, hello to everyone...
so, i have taken apart my bike for winter for repainting and some tuning, and now i have this lil problem, im trying to fit gfr rearfork into my sp01 and from what ive heard, gfr/sp01/sp02 all have same frame, but for some reason the fork doesnt fit into it (the triangular piece doesnt fit into rearfork) so any ideas?
Posted: Tue Oct 18, 2005 6:58 pm
by Markus
Do you have the two little small Aluminium parts,too?
Maybe the triangular piece is different, I will look after it tomorrow.
Posted: Wed Oct 19, 2005 5:09 am
by Rubberduck
i have all the parts from it, but from what ive tried to assemble it, the triangular bit seems to be ~5mm´s too left (it hits the rearfork instead of going between it)
Posted: Thu Oct 20, 2005 2:10 pm
by Rubberduck
any help guys? id like to get my gilera on wheels this year <.<
Posted: Thu Oct 20, 2005 3:24 pm
by hahne
Do you mean the holder for brake-caliper ?? There I have 3 types: all the same, only difference : the housing for rear-axle ! the small one is 21,5 mm, the biggest is 35 mm width ...and then the middle ( SP02, sorry, not possible to give you measure of the middle one, is on the bike! )
Cheers Gottfried
Posted: Thu Oct 20, 2005 4:05 pm
by Rubberduck
i mean the triangular piece where "dog bones" rearshock and rearfork are attached to...
that image should clarify the problem, as you can see, the triangular piece is not lined to rearfork, its roughly ~5mm´s off the line...
Posted: Thu Oct 20, 2005 6:55 pm
by hahne
Simple way: cut the one side ... and do it on the other side, ....or take a new one bushing for other side. Bye Gottfried
Posted: Thu Oct 20, 2005 7:02 pm
by Rubberduck
you think i should just cut the rearfork enough that it fits?
Posted: Thu Oct 20, 2005 8:21 pm
by gileramad
Not the fork - the "triangle"
--I--- <- before
--I-- <- after
And then put some tube that equalizes the parts you cut out on the other side.
---I--
But i don´t know what this means for the stability of your bike...
...might be a bad idea.
Posted: Thu Oct 20, 2005 8:22 pm
by hahne
Posted: Thu Oct 20, 2005 8:25 pm
by hahne
....ahhh the chief was faster!!!
....I think no problem ! Bye Gottfried
Posted: Fri Oct 21, 2005 6:16 am
by Rubberduck
hmmmm, maybe i should machine a new triangle part for it?
but, it shouldnt make my bike wobbly or anything, since it doenst change the rearfork/frame line....
Posted: Fri Oct 21, 2005 2:50 pm
by Markus
Do you have both trainagle parts?
GFR and SP01
Are they really no differences?All frames have the same base, but they are all different!Even SP01 and 02!
Posted: Fri Oct 21, 2005 4:00 pm
by Rubberduck
i only got the triangle part for sp01, but shouldnt they be same?
Posted: Fri Oct 21, 2005 8:30 pm
by Markus
I will look for it tomorrow.I have a GFR and a SP01
