Page 1 of 1

Bolar

Posted: Mon May 28, 2018 6:07 pm
by geert pardon
Hi all,

Finally started making my bolar hats.
IMG_20180528_184548_1_resized_20180528_064637530.jpg
IMG_20180528_184548_resized_20180528_064637894.jpg
IMG_20180528_184536_resized_20180528_064638195.jpg
IMG_20180528_184509_resized_20180528_064638480.jpg
:nix: ....geert

Re: Bolar

Posted: Mon May 28, 2018 6:52 pm
by Joachim
*thumb*

it's hard to put stickers on 'round' surfaces isn't it giggle

ciao Joachim

Re: Bolar

Posted: Mon May 28, 2018 7:03 pm
by geert pardon
yup, I even tried the wet procedure, but the water didn't stick on the plastic.
But it could be worse.....geert

Re: Bolar

Posted: Mon May 28, 2018 8:20 pm
by Joachim
problem is that the stickers have rather small areas to stick.
So they may fall of when wet

:? Joachim

Re: Bolar

Posted: Mon May 06, 2019 7:16 pm
by geert pardon
Ok summer can start.
Prototype is ready
IMG_20190506_200354.jpg
Gileragreetings...geert

Re: Bolar

Posted: Mon May 06, 2019 7:56 pm
by Joachim
rulez

looks like the radius was ok
The GILERA Design may also look even better when it was a little bend.
Next time giggle

The duck on the righthand side has a lot of fun with your new chair

ciao Joachim

Re: Bolar

Posted: Sun Jul 26, 2020 8:29 pm
by geert pardon
Now I can fill up in style....
Gileragreetings....geert
IMG_20200722_211733.jpg

Re: Bolar

Posted: Sun Jul 26, 2020 8:43 pm
by Joachim
*danke*

ciao Joachim